| Erecting an Inflatable: |
| |
|
| |
|
| 1. |
Locate the smoothest, most level place in your garden. If
it is going on a rough, dry, abrasive piece of land or concrete,
you need to place a groundsheet underneath the unit. Also ensure
that the unit will not touch any overhanging branches, verandas
or roofs. |
| |
|
| 2. |
Always check the area where the Inflatable is to be erected
for any large stones, sticks or any other items that may cause
damage to the unit and remove it promptly. |
| |
|
| 3. |
Remove the Inflatable from the bag, unroll and unfold the
unit. |
| |
|
| 4. |
Position the inflatable as required. Spread out the sides
as much as possible. Please do not drag the unit over an abrasive
surface as this will cause damage to the inflatable. |
| |
|
| 5. |
Connect the blower to the inlet tube of the inflatable and
secure with the rope/Velcro strap. |
| |
|
| 6. |
Close any deflation zips that are generally located on the
bottom/side of the inflatable. |
| |
|
| 7. |
Fully unroll the extension cable to prevent the cable from
overheating. Electrical cables should be laid such as not to
pose a hazard of tripping over. They should also be fully protected
from damage of water. |
| |
|
| 8. |
Plug blower cable into extension socket and allow Inflatable
to inflate completely. NO persons
allowed on inflatable whilst it inflates. Inflation
takes approximately 2 minutes. The blower MUST remain running continuously whilst the inflatable is being used. |
| |
|
| 9. |
Please anchor the unit using the anchor points located around
the base of the unit. Ensure that the stakes are well into the
ground so as to prevent injury to children. |
| |
|
| 10. |
Keep Children away from the blower and electricity supply. |
| |
|
| |
|
| Folding an Inflatable |
| |
|
| |
|
| 1. |
Make sure ALL children and debris
are removed from Inflatable. |
| |
|
| 2. |
Switch off the electrical supply and disconnect the blower. |
| |
|
| 3. |
Remove inlet tube from blower and open deflation zip. |
| |
|
| 4. |
Allow enough time for the inflatable to deflate completely. Deflation takes approximately 5-15 minutes depending
on size of inflatable. |
| |
|
| 5. |
Straighten the base of the inflatable and and fold in any
walls or tubes towards the centre. |
| |
|
| 6. |
Fold inflatable lengthwise. Roll unit slowly and as tightly
as possible towards the outlet zip, forcing the air out. Remember
that if you start small, you will end small and vice versa. |
| |
|
| 7. |
Place the bag over the rolled up unit and roll inflatable
in to bag. Secure the bag with the fastening rope or belts. |
| |
|
| 8. |
If the inflatable is wet when folding due to rain or for any
other reason, please ensure that you erect it as soon as possible
to allow unit to dry properly. Also inform agent if the inflatable
is wet so that they can do the same. Under no circumstances
should the unit be stored wet for any length of time since this
causes damage to the unit. |
| |
|
